Projecta: Worksheet -

Section : . InaSAFE Tools

Module : . Exercise – MultiBuffer

Using the multibuffer tool in InaSAFE

“The multi-buffer tool provides a quick way to generate a polygon hazard dataset from a point hazard layer. In this exercise we show you a use case for using this tool.”

We mentioned previously that InaSAFE does not work with point hazard data. However there is a tool provided with InaSAFE that will produce concentric zones around a point-based hazard and assign a category to each zone. You can then treat this as a hazard layer, defining keywords for it and running your InaSAFE analysis.

You try:

Goal: To generate a hazard layer from a point dataset and use it in an analysis.

Add the chemical-spill dataset to QGIS.
Use the multi-buffer tool (there is no toolbar icon for it so look in the Plugins -> InaSAFE submenu) to create a polygon dataset with three zones as indicated on the table, right.
Define keywords for the newly generated layer, taking care to set the hazard classifications as shown on the table below
Now run the chemical spill on buildings InaSAFE analysis using the wards layer for aggregation.

Check your results:
How many buildings were affected in each hazard zone? Do your results match your neighbour’s?

Name	Expectation
Buffer Zone Severity:
High	15
Medium	30
Low	50
Keywords
purpose	Hazard
Kind	Generic
Scenario	Single event
Classified field	Hazard_class
Hazard classifications:
Generic on Landcover	Generic classes
Generic on Population	Generic classes
Generic on Roads	Generic classes
Generic on Structures	Generic classes
Hazard id	id (or blank)
Source, URL, Scale, Date, License	Fill in as needed
Title	Chemical Spill on buildings aggregated by wards.
Analysis	Chemical spill on buildings aggregated by wards.

More about

You can do the multibuffer process manually using standard tools in QGIS, but the InaSAFE Multibuffer tool makes the whole process very easy to buffer at multiple zones, add the needed keywords for InaSAFE and then use that layer as a hazard layer in InaSAFE.

Using buffer zones around a hazard should be based on a good scientific or knowledge based approach, otherwise the results produced may not be useful or may be misleading.

Check your knowledge:

InaSAFE does not support point using hazard data:

True

False

Mark all the correct statements:

The multibuffer tool provides a way to run an analysis with hazard data derived from point data.

The multibuffer tool works with polygon and line layers too.

It is not possible to generate a multibuffer dataset without using the InaSAFE multibuffer tool.